Waste / Water
Max Temp Allowed
130 deg F
RONCO MARINE TANKS should always be stored out of direct sunlight and
protected from freezing. Prior to installation, tanks should be at
room temperature for a minimum of six (6) hours. The tank must be
installed on a flat or contour matched surface, be clean and totally
supported in all planes with 1/2" - 3/4" marine plywood or equivalent.
Install tubing and fittings so that there are no
points of stress on the tank. use elbows to prevent partial bending or
collapsing of the tubing when a change in direction is required.
Plastic tank connections are designed to seal
dry. Compounds such as sealants, pipe dopes, greases, petroleum
jellies, glues or adhesives are not to be used. Normally, hand
tightening will provide adequate seal. On occasion, a slight
tightening with a wrench may be required. To avoid damage to seal
fittings, do not apply excessive force. Do not exceed 1/4 turn after
Do not install metal fittings in the plastic tank as the materials are not compatible.
Should you desire to test the potable water tank or water system for leaks, fill with water and check visually.